Emissions Testing Services (continued)

Emissions Services Offered By Windrock

EPA Title V Compliance Testing

Windrock Service provides all of the equipment and personnel necessary to perform a full Title V test including developing an emissions test protocol based on the operator’s source permit, conducting the required tests, and issuing a full test report in accepted EPA book form or electronic format. EPA Methods that Windrock are capable of performing are 3A, 7E, 10, 18, 19, 20, 25A, and 320.

Pre-assessment Health Testing, Diagnostic/Troubleshooting Services

Windrock provides this service to any operator who wants to know if their equipment is running properly with regard to performance, mechanical condition and/or emissions. Our experienced staff can test your engines, evaluate the data and offer detailed recommendations to resolve any deficiencies in performance, mechanical condition and/or emissions prior to your scheduled emissions tests.

Consulting Services

Windrock test engineers can provide a wide range of consulting service to assist the operator with engines not operating in compliance with permits. Such services range from determining the root cause why a unit is not operating in compliance to recommending or designing specific remedial solutions to the problem.

Periodic Testing

Windrock can conduct the annual periodic tests required to assure a unit is operating in compliance with its permit. Such tests typically involve a 30-minute run to measure NOx, CO and occasionally VOCs. Windrock can provide either a trailer or portable analyzer for testing depending on the specific requirements.

Mapping and Development of Control Coefficients

WIndrock provides services to map engine performance and develop air/fuel ratio control coefficients designed for emissions compliance under normal operating conditions. This service is based on the use of a test matrix that employs an air equivalence ratio model for mapping and predicting emissions. Once the model is developed, the coefficients are created for use in the unit’s automation control scheme. NOTE: This service is only available for slow speed integral units.

RATA Testing

RATA tests to verify that CEM (continuous emissions monitoring) systems are operating properly.

Catalyst Testing

Catalyst tests to check the efficiency of the catalyst for CO and NOx or HCHO.

Ammonia Slippage Test

Ammonia slippage test to tune the ammonia injection rate and test for ammonia slippage past the NOx catalyst.

CEM Systems

Windrock services can offer complete CEM packages from engineering, design, manufacture and installation through Control Analytics Inc.

Horsepower and Mechanical Condition Testing

Windrock offers test equipment and services for horsepower testing/verification and mechanical condition analysis on slow or high-speed engine/compressor sets.

1 | 2

Please contact Mr. Jim Strobe -
EMAIL jstobbe@windrock.com • MOBILE PHONE: (724) 833-0748